- Joined
- Dec 21, 2006
- Messages
- 3,158
Can't seem to shake this one! Oh well, back into the ring!
Aldo's W2 tool steel!!!
Beautiful walnut handle
Black G10 liners
Jimping on the spine
"W2" etched on one blade side, "S" on the other
Specs:
OAL: 9.00"
Handle: 4.50"
Blade: 4.50"
Cutting edge: 4.25"
Thickness @ ricasso: .130"
Tang has holes milled out for weight/balance
Balance point is just in front of front handle pin, right at forefinger placement
W2 steel fully normalized, thermal cycled, P50 quench, triple tempered @ approx 61-62HRC
Hand sharpened with Arkansas stones @ approx 30 degree total edge.
Finished on translucent Arkansas stone, then fine ceramic stone
No sharpening choil. Can be cut if customer desires!
Leather sheath included. Free shipping anywhere in the lower 48 states.
As always, I welcome your comments and critiques!
$149 shipped to your door!
S Davenport Knives
San Antonio, Texas
paypal address: samuraistuart@yahoo.com
Beautiful walnut handle
Black G10 liners
Jimping on the spine
"W2" etched on one blade side, "S" on the other
Specs:
OAL: 9.00"
Handle: 4.50"
Blade: 4.50"
Cutting edge: 4.25"
Thickness @ ricasso: .130"
Tang has holes milled out for weight/balance
Balance point is just in front of front handle pin, right at forefinger placement
W2 steel fully normalized, thermal cycled, P50 quench, triple tempered @ approx 61-62HRC
Hand sharpened with Arkansas stones @ approx 30 degree total edge.
Finished on translucent Arkansas stone, then fine ceramic stone
No sharpening choil. Can be cut if customer desires!
Leather sheath included. Free shipping anywhere in the lower 48 states.
As always, I welcome your comments and critiques!
$149 shipped to your door!
S Davenport Knives
San Antonio, Texas
paypal address: samuraistuart@yahoo.com
