Wanted: Benchmade mods.

[Murphnuge]

Here's my problem, I just switched from carrying a Benchmade Stryker in 154cm to a Benchmade Bone Collector Axis. My Stryker was tip-down carry with a thumbstud and my Axis is tip-up with a Spyderco hole. I've tried to get used to it, but it ain't happening. I'm looking for someone that could remedy this for me. I would like to switch the Axis to a tip-down configuration and install a thumstud. Price is negotiable. I'll pay shipping both ways. You can pm me if you can do the job.

Pic of my Stryker(top) and Axis(bottom)

 

[Murphnuge]

Just curious, but is this mod impossible? I only ask because I've received zero feedback on this project.

 

[BenR.T.]

For the clip it would depend on whether or not the handle scale could be drilled and tapped, I have never tapped g10, not sure if would strip out or not.
The thumb stud should be pretty straight forward, the problem is getting a drill bit to go through a hardened blade. your best bet might be finding a local gunsmith to do it, he should have all the tools needed, if it is possible.

 

[Murphnuge]

Thanks Ben! I've got a go-to gunsmith that may do it. I'll leave this here in hopes that someone picks up on it if he doesn't.

 

[Murphnuge]

Still no takers on this yet.