War Horse Recurve Fighter @@SOLD@@

J

J. Hoover

Feedback: +61 / =0 / -0
Joined
Jul 2, 2006
Messages
1,782
SOLD
Made this one from Aldo's 52100 steel. Sweet curves along with a sharpened clip make this one bad to the bone. Here are the specs:

Steel- 52100 X 3/16 approximately
AOL- 12 inches
Grind- Flat double ground
HT- In house, double quenched with 3 two hour temper cycles
Blade- 7 inch hair popping edge with 4 3/4 inch sharpened clip.
Finish- Hand sanded to 2000 grit
Handle- Approximately 5 inches
Scales- Green G10
Hardware- 416 stainless tube and stainless Loveless bolt
Sheath- .80 Concealex set up for YOUR large Tek-Lok. Vertical or Horizontal carry, left or right handed.
Asking 275.00 shipped in the USA or Canada
Paypal, USPS M/O, or Certified check preferred. Email for other options
Questions or comments welcomed
Thanks for looking

001-94_zps6f123263.jpg


002-98_zps2eebd232.jpg


003-92_zpsca70a4ed.jpg


004-85_zps58ce3d09.jpg


008-57_zps744abf92.jpg
 
Last edited:
Thanks guys this one is nasty for sure. I don't do many with a sharpened clip. You have to be careful handling them, this will definitely bite you before you know it.
 
Last edited:
I can't believe this hasn't sold - this is a FINE tactical utility with excellent lines.
 
I just spent my allowance or I would be all over this. It is PERFECT!
 
You must log in or register to reply here.
Back
Top