- Joined
- Dec 21, 2006
- Messages
- 3,158
A simple EDC Warrny!
OAL: 8 3/4"
Blade: 4"
Handle: 4 3/4" (to the front protrusion)
Thickness: .107" at ricasso
Steel: Aldo's 52100 fully normalized and cycled
Wood: Bubinga with Danish and TruOil finish
Edge: 30° inclusive @ 2K finish .010" at shoulder
This was a really fun project! If this one is gone and you want one, I'll make it! Any of my knives, for that matter!
Asking $200 complete with Kydex sheath and belt/boot clip and chicago screws for easy tear down/clean up...and shipping to your door!!! (lower 48 only, anywhere else...we will figure it out)
Paypal address: samuraistuart@yahoo.com Paypal preferred, but will accept checks and money orders.
www.stuartdavenportknives.com
Facebook: Stuart Davenport Knives
OAL: 8 3/4"
Blade: 4"
Handle: 4 3/4" (to the front protrusion)
Thickness: .107" at ricasso
Steel: Aldo's 52100 fully normalized and cycled
Wood: Bubinga with Danish and TruOil finish
Edge: 30° inclusive @ 2K finish .010" at shoulder
This was a really fun project! If this one is gone and you want one, I'll make it! Any of my knives, for that matter!
Asking $200 complete with Kydex sheath and belt/boot clip and chicago screws for easy tear down/clean up...and shipping to your door!!! (lower 48 only, anywhere else...we will figure it out)
Paypal address: samuraistuart@yahoo.com Paypal preferred, but will accept checks and money orders.
www.stuartdavenportknives.com
Facebook: Stuart Davenport Knives
