One I just finished up today, locks up bank vault tight with no movement in any direction. Good strong detent so no worries on getting surprised when you reach into your pocket. Riding on bronze washers it opens smoothly and locks up with a satisfying click. Here are the specs:
Closed length- 5 3/8 inches
Opened- 9 inches
Steel- A2 Tool Steel
HT- In house to a tested 60rc
Blade- Wharnecliffe
Grind- Flat ground with drawn swedge and jimping. Silly sharp polished convex edge
Finish- Hand saded with a matte finish
Frame- .140 anodized titanium
Pivot- .250 stainless pivot with bronze washers
Stop pin- 1/8 hardened stainless
Hardware- Stainless standoffs and screws
Clip- Low ride titanium situated for point up right hand carry
Asking 375.00 shipped in the USA
Paypal, USPS M/O, or Certified check preferred
Questions or comments welcomed
Thanks for looking
Closed length- 5 3/8 inches
Opened- 9 inches
Steel- A2 Tool Steel
HT- In house to a tested 60rc
Blade- Wharnecliffe
Grind- Flat ground with drawn swedge and jimping. Silly sharp polished convex edge
Finish- Hand saded with a matte finish
Frame- .140 anodized titanium
Pivot- .250 stainless pivot with bronze washers
Stop pin- 1/8 hardened stainless
Hardware- Stainless standoffs and screws
Clip- Low ride titanium situated for point up right hand carry
Asking 375.00 shipped in the USA
Paypal, USPS M/O, or Certified check preferred
Questions or comments welcomed
Thanks for looking
Last edited:
