What I've been up to

Thats wild looking Will...Now lets see a picture of you beating some hot steel with it:D
Bruce
 
Just got done welding some Oregon chainsaw chain, and she works great! Has a few quirks, like after the first few minits of runing it started to shed some nuts and bolts:D

Unfortunatly the chain was full of inclusions. Better than the last try, but not there yet.
 
COOL Will, I would like to see a bigger picture through, hard to make it out real good, I was going to make 1 of those before I came across this Power hammer. Whats the hammer weight??

Bill
 
Bill, it's got a 50lb. hammer. All in all it took more time to run down materials than to build. Total cost is 400.00$, mainly because I was in a hurry and had to buy new motor and pullies and pillow block bearings. I probly could have built it a lot cheaper if I'd had time to gather materials.
 
You must log in or register to reply here.
Back
Top