Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,176
Well she named it , I ground it to be a caper / B & T knife . It has a full flat grind from edge to spine from 5/32" A-2 PFG tool steel bar stock . Heat treated in my shop to an Rc 61 , the sweet spot for this steel .
I put a hand sanded satin finish on the blade down to a 600 grit wet/dry SC paper . It has a very pronounced distal taper and a rounded spine . Enough talk , here are the specs and pics .
O.A.L is 8"
Blade tip to handle is 3-1/2" , and 1" wide edge to spine
Sharpened edge is 3-3/8"
It is handled up in Stabilized Maple Burl and 5/32" mosaic pins .
The sheath is left or right hand carry , 8-9 oz .
sold
$155.00 shipped in the USA . International friends write for cost . Pay-Pal , Postal M/O or check ( held to clear ) . My PP is sugarland@wwest.net
Thank you all for viewing my work and offerings . It is truly appreciated and comments always welcome .
View attachment 390050View attachment 390051View attachment 390052View attachment 390053View attachment 390054
I put a hand sanded satin finish on the blade down to a 600 grit wet/dry SC paper . It has a very pronounced distal taper and a rounded spine . Enough talk , here are the specs and pics .
O.A.L is 8"
Blade tip to handle is 3-1/2" , and 1" wide edge to spine
Sharpened edge is 3-3/8"
It is handled up in Stabilized Maple Burl and 5/32" mosaic pins .
The sheath is left or right hand carry , 8-9 oz .
sold
$155.00 shipped in the USA . International friends write for cost . Pay-Pal , Postal M/O or check ( held to clear ) . My PP is sugarland@wwest.net
Thank you all for viewing my work and offerings . It is truly appreciated and comments always welcome .
View attachment 390050View attachment 390051View attachment 390052View attachment 390053View attachment 390054
Last edited:
