G L Drew
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 3, 2005
- Messages
- 4,804
52100 high carbon steel
Heat treated in my Evenheat kiln with three 20 minute normalizing cycles and two tempering cycles for 1 hour each. This achieves a hardness of Rc 58-60 and a fine grain structure throughout the blade.
Flat grind with a 400 grit belt finish
Brass fixtures with G10 spacers
Bone handle that I jigged and dyed
Overall length: 8 inches
Blade:3 3/4 inches
Leather scabbard with a belt loop for a right hand carry
Sold delivered within the US. My PayPal and email is gldrewknives@gmail.com
IMG_8525 by Gerald Drew, on Flickr
IMG_8526 by Gerald Drew, on Flickr
IMG_8528 by Gerald Drew, on Flickr
IMG_8529 by Gerald Drew, on Flickr
IMG_8531 by Gerald Drew, on Flickr
Heat treated in my Evenheat kiln with three 20 minute normalizing cycles and two tempering cycles for 1 hour each. This achieves a hardness of Rc 58-60 and a fine grain structure throughout the blade.
Flat grind with a 400 grit belt finish
Brass fixtures with G10 spacers
Bone handle that I jigged and dyed
Overall length: 8 inches
Blade:3 3/4 inches
Leather scabbard with a belt loop for a right hand carry
Sold delivered within the US. My PayPal and email is gldrewknives@gmail.com
IMG_8525 by Gerald Drew, on FlickrIMG_8526 by Gerald Drew, on FlickrIMG_8528 by Gerald Drew, on FlickrIMG_8529 by Gerald Drew, on FlickrIMG_8531 by Gerald Drew, on Flickr
Last edited:
