- Joined
- Dec 31, 2009
- Messages
- 2,630
Hello to All, I built and sold one other knife like this just before moving from Portland Or. This one has my new Logo. Hope you like it.
Blade is CPM 154 .144 thick, and 3. in. tip to guard. Heat treated with sub zero quench and double tempered. Hollow ground with 10 in. wheel. I taper the tang from right behind the guard and it is hollow ground as well leaving about .187 at the edge all around, so the scales fit perfectly tight against the tang. Blade is polished and finished with 2000 grit.
Guard is 416 stainless pinned and very carefully silver soldered. Fillet is full, and even with NO pin holes.
Handle is some Nice K&G stabilized maple burl with mosaic pins, thin yellow and black liners.
Lanyard hole is brass.
Sheath is hand tooled, and hand stitched 8-9 ounce leather. The knife fits nice and snug yet is easy to withdraw.
Asking (withdrawn) shipped in the USA. My paypal is warrencustomknives@yahoo.com
Thanks for having a look. Alan
Blade is CPM 154 .144 thick, and 3. in. tip to guard. Heat treated with sub zero quench and double tempered. Hollow ground with 10 in. wheel. I taper the tang from right behind the guard and it is hollow ground as well leaving about .187 at the edge all around, so the scales fit perfectly tight against the tang. Blade is polished and finished with 2000 grit.
Guard is 416 stainless pinned and very carefully silver soldered. Fillet is full, and even with NO pin holes.
Handle is some Nice K&G stabilized maple burl with mosaic pins, thin yellow and black liners.
Lanyard hole is brass.
Sheath is hand tooled, and hand stitched 8-9 ounce leather. The knife fits nice and snug yet is easy to withdraw.
Asking (withdrawn) shipped in the USA. My paypal is warrencustomknives@yahoo.com
Thanks for having a look. Alan
Attachments
Last edited:
