withdrawn

[wwells20]

Blade: 3" A-2 tool steel, Tanto/Chisel tip, flat ground with a convex edge from 1/8" stock. Heat treated to 62 HRC with -300 cryo cycle by Peters' of PA.

Handle: 4" Blue/Black G-10, 1/8" stock with a pearl red Kirinite back spacer, nested TI liner lock, 3/16" pivot, 5/32" stop pin, all stainless hardware. Blade rides on phosper bronze washers.


Clip: 2 1/8" stainless, set for right hand, tip up carry. *I can switch the clip if needed. Knife weighs 2.50 oz.









Price: withdrawn shipped CONUS with 100% satisfaction guarantee.

PayPal preferred, P/P address wwells63@aol.com , USPS Money Order or check.
first "I'll take it" gets it.
Thanks for looking, Walter

 

[mycough]

Nice one Walter. Love the contour ing of the scales. Russ

 

[Lycosa]

I dig the point... and the folder.
Someone get this. You will love this folder.
rolf

 

[not a zombie fan]

Nice. If this were over 3 inches id be in danger of nabbing my third. Love both my friction folder and liner lock.

 

[wwells20]

Nice. If this were over 3 inches id be in danger of nabbing my third. Love both my friction folder and liner lock.

You know I take special orders (wink, wink) I need to think bigger, I guess......thank you for your support, Walter

 

[mycough]

Nice. If this were over 3 inches id be in danger of nabbing my third. Love both my friction folder and liner lock.

I don't think Walter ever said how long the blade was, just the handle and the clip. Russ

 

[Lycosa]

Yea... a 3.5" blade, Walter.
GO!!

 

[mocotaugan]

Still available?

 

[mocotaugan]

If so I think I'll take it!

 

[Pfd1980]

Very well done. Sharp looking knife

 

[wwells20]

If so I think I'll take it!

You got it. My PayPal address is wwells63@aol.com.

 

[Lycosa]

Nice grab, moco.
rolf