Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,193
Hello folks , for your consideration I have this newly finished Hunter to offer .
This knife has a full height flat grind with a full distal taper from 5/32 " A-2 tool steel and a hand sanded satin finish down to 400 grit from black silicon carbide wet/dry paper . Heat treated with the sub-zero soak treatment to an RC 61-62 .
It measures 8-1/4" overall with a 4" blade , a 3-1/2" cutting edge with a sharpening choil and 1-1/8" wide . Handled up in some exhibition grade stabilized Desert ironwood with red liners , copper Corby bolts and a center mosaic pin .
Sheath is right hand carry .
Thank you for looking at my offerings and as always comments welcomed ( good I hope ) .
Jack O'Neill
This knife has a full height flat grind with a full distal taper from 5/32 " A-2 tool steel and a hand sanded satin finish down to 400 grit from black silicon carbide wet/dry paper . Heat treated with the sub-zero soak treatment to an RC 61-62 .
It measures 8-1/4" overall with a 4" blade , a 3-1/2" cutting edge with a sharpening choil and 1-1/8" wide . Handled up in some exhibition grade stabilized Desert ironwood with red liners , copper Corby bolts and a center mosaic pin .
Sheath is right hand carry .
Thank you for looking at my offerings and as always comments welcomed ( good I hope ) .
Jack O'Neill
Last edited:
