Woo Hoo... Grizzly 10" wheel is being delivered today

[AVigil]

I will be picking up some bearings from Graingers they are bringing in for me and I think I found a machine shop to mill the wheel for the bearings.

You know one of the knife supply company should stock the Grizzly 10" wheels with bearings and sell them for $190. I bet they would sell well.

 

[javand]

Before you bore it out, can you tell me what the size of the shaft hole is and wether it has a keyway in it?

I've considered using one of these as a large drive wheel before but couldn't find the specs.

 

[AVigil]

Looking here http://cdn0.grizzly.com/manuals/g1015_m.pdf

It says the dia is 3/4" and it does not look like there is a keyway

 

[javand]

Ahh k. Thanks man

 

[Rick Marchand]

I can take mine off and mic it if you want?

ETA:
ID - .7505"
Bore length - 1.470"
No Key

 

[AVigil]

I can take mine off and mic it if you want?

Oh please God let him be talking about the contact wheel

 

[javand]

Rick did you mount one with pillow blocks as a contact wheel or you got an actual Grizz 2x72?

Its no big deal, probably an idea I won't even follow through with. Thanks though.

 

[Rick Marchand]

Oh... yeah... actual grizz sizes. Check out my first post.

 

[12345678910]

I can take mine off and mic it if you want?

ETA:
ID - .7505"
Bore length - 1.470"
No Key

Is that 8 or 10" wheel ?
How about the ID and depth of the rim step ?

 

[javand]

Thanks Rick. If I happen across a 3/4 shaft motor that might be the ticket. So far most of them I've found have been 5/8.

 

[Rick Marchand]

Is that 8 or 10" wheel ?
How about the ID and depth of the rim step ?

That is the 8" wheel... I was using it to give the measurements of the shaft hole for javand.

 

[Brian.Evans]

Rick did you mount one with pillow blocks as a contact wheel or you got an actual Grizz 2x72?

Its no big deal, probably an idea I won't even follow through with. Thanks though.

I'd like to know this too. I've got some razors I need to get done.