WTB Wanted to buy 440v 1/8 thick

Status
Not open for further replies.
ken erickson

ken erickson

Knifemaker / Craftsman / Service Provider
Feedback: +18 / =0 / -0
Joined
Aug 27, 2004
Messages
2,701
I was hoping someone may have some 440V in 1/8 thick laying around. I do not need much as I have about 1/2 the amount to complete a 3 blade cattle knife.
Even if the pieces are cut-offs they may still work for me.

If you have some you can part with, please let me know either here, PM or email.

Thanks in advance!
 
Last edited:
blades&grace said:
I have a little but its .140 & 1 5/8 wide. How long will work ken?
Click to expand...

Brent, Before committing to the .140 perhaps another member will have some 3/32? I hate to surface grind your piece down to my needed specification. It would be best if you can hang on yours for a future project. Thanks!
 
Brent,

I just about made a big mistake and was corrected by my customer. I do need stock that will finish out to 1/8. So, I don't know if you want to hang on to what you have, or if your willing to sell it. It is a pretty large knife, and to make the 3 blades, I think I would need a minimum of 6 to 8 inches by the 1 5/8. I also would be happy to send back what I do not use, you could figure a price and whatever you want for it would be fine.
 
Status
Not open for further replies.
Back
Top