WTT Baldor CM3555 2HP, 3ph, TEFC motor

[Phantom Steelworks]

Trade Pending

Looking to trade my Baldor. My second grinder has been put on the back burner for now, so I am offering it up.

Like new minus a couple scratches on exterior. Excellent motor for your grinder build-KMG what have you.

It is a Baldor CM3555 2HP, 56c, TEFC, 5/8" shaft

Specs can be seen here:
http://www.baldor.com/products/detail.asp?1=1&page=67&catalogonly=1&catalog=CM3555&family=General+Purpose|vw_ACMotors_GeneralPurpose&product=AC+Motors&winding=34WG0284&rating=40CMB-CONT

Looking to trade for:

Steel: A2, D2, 0-1, Stainless etc
G-10, Micarta, Carbon Fiber

Possibly other knife making related items, but for now could sure use some steel and G-10 etc2thumbs

I dont really have a trade value set in mind. We all know what they go for, I am not at all looking for retail. Just a good trade!

Thanks for looking.

Chris

 

[Norcalflat]

Anything in either of these interest you?

http://www.jerzeedevil.com/forums/showthread.php?t=76080

http://www.jerzeedevil.com/forums/showthread.php?t=79669


I also have a few other scale sets of desert ironwood, some unstabilized curly maple, titanium .1 sheets 2" x 14", wood handled strop made by one of the members here, some 1/4" firesteels and magnesium rods, bunch of Blade magazines, 12.5+" brass bar and 1/4" pinstock(although it is not matched), that's about all I can think of at the moment.

 

[Phantom Steelworks]

Email sent.:thumbup:

Anything in either of these interest you?

http://www.jerzeedevil.com/forums/showthread.php?t=76080

http://www.jerzeedevil.com/forums/showthread.php?t=79669


I also have a few other scale sets of desert ironwood, some unstabilized curly maple, titanium .1 sheets 2" x 14", wood handled strop made by one of the members here, some 1/4" firesteels and magnesium rods, bunch of Blade magazines, 12.5+" brass bar and 1/4" pinstock(although it is not matched), that's about all I can think of at the moment.