WTT for Chris Reeve / Pimped Emerson Knives

Status
Not open for further replies.
Feedback: +95 / =0 / -0
Joined
Jun 28, 2010
Messages
1,952
I am interested in trading for one (maybe two) of the following:
  • Chris Reeve Small Sebenza CGG Web-Sight
  • Chris Reeve Small Thuya Annual Sebenza
  • Chris Reeve Small Regular Sebenza
  • Scott Cook Lochsa (Pipe Dream, I know) :(
I will also consider:
  • Chris Reeve Umnumzaan
  • Pimped Emerson Mini CQC-7 / Mini CQC-15 (looking for stonewashed blade, titanium lockside)
  • Possibly Emerson CQC-7V
  • Possibly Spyderco Techno but this is at the low end of my interest list
  • Will also consider other flashlights (Muyshondt) or firearms (Kahr P380, MK9)

Terms:
  • Must hold Gold Membership or above, and be established and in good standing (good feedback, good communication)
  • Inspection period to be agreed upon (thinking 1-2 days though)
  • For a trade involving a firearm going to you: 1) Shipped to your FFL from mine, or FTF if you are close, 2) Must be 21 or older, 3) You must be able to legally own this firearm and this firearm must be legal to own in your area

What I have to trade
I only own two knives at the moment, so I am looking to add to this. I have always enjoyed Chris Reeve Knives and sadly let the ones that I did own go. I now realize I should have held on to them. I have gadgets and gear up for trade. I can combine items if need be. Please send any questions via PM.

1) Sig Sauer P238 Diamond Plate - Sold on another forum
The Sig P238 comes with SigLite Night Sights, case, and standard 6 round magazine. It has about 350 rounds through it and has run without issue (no FTF's, FTE's). Plastic trigger has been replaced with a stainless steel one. Some marks on the frame from doing the swap (see photos down below). The mod was completed by dannyv, whom I also purchased this from here: http://www.bladeforums.com/forums/showthread.php/984590-Sig-p238-Diamond-plate-design


Click on the photos to enlarge them






2) Kimber Ultra Carry II
I purchased this used from Mag1 here: http://www.bladeforums.com/forums/s...229-40-and-HK-USP-Tactical-45-with-Eagle-Case

I have since put about 200 rounds through it, I found it shoots well (or I shoot it well ;)). Only thing is I don't shoot it as much as I would like and while I would not mind keeping it, I also would not mind moving it if it will help me net one of the above items. It comes with 2 7-round mags, Hogue wrap around grip, and case.





3) Garrett Industries Kahr CM9 Silent Thunder IWB With Tuckable Belt Loops
Great leather-lined kydex provides a quiet holster/draw. This has not been carried, however I have holstered my CM9 in it. There is a sharp edge on the frame that has caused a rip in the leather (refer to photo). Make sure to round this edge on your frame to prevent further tearing. Please note that this does not affect the functionality of the holster.

Includes the tuckable tan loops, slimline clip, and standard clip - each are for a 1 1/4" belt. Right handed carry. Purchasing altogether and with shipping it will come out to about $127.50 on their website and about a months build time, in Texas with Tax it would be $135.06. I am only asking for $90 and it is available now. This price does include Priority shipping in a small flat rate box.



4) Soeks 01M Radiation Detector 2013 version
I purchased this brand new as I was curious and wanted to check out background radiation in my neighborhood and workplace, as well as check some scrap metal that my dad recently purchased. Gladly, no high readings were given. I don't have a use for it anymore and hope someone else can put this to good use. The plastic is still on the screen; languages are: English and Russian. Runs on 2 AAA batteries (2 AAA eneloops included). Price includes priority mail shipping in a small flat rate box.


 
Last edited:
5) ArcLS First Run #726 Triple Nichia 219
Wonderful light and beautiful neutral white tint. I cut a piece of Delrin to help keep the battery from rattling. The Nichia emitters offer excellent color rendering. Here is some info from datiLED over on CandlePowerForums regarding it:

The Arc triple has three Nichia 219 LEDs in parallel, driven by an AMC 3-level regulator board. The optic is a Carlco 10507 narrow array. The heatsink is a solid piece of turned aluminum that contacts the inside of the head for good heat dissipation.

Using a quality 750mAh RCR cell, 70mA should give at least 11 hours of runtime, 420mA should give at least 90 minutes of runtime, and 1400mA should give a little more than 20 minutes. This is based on cell capacity and current drain, with some fudge factor applied. I think that the light would get pretty hot after 20 minutes on high. The heatsink is massive, but the light is small. That is a lot of heat to dissipate. I only tested the high level for 10 minutes, or so. It got warm, but I was holding the light with a full hand grip.

The light can use any RCR cell, and IMR's are recommended. The levels are set at 70mA, 420mA and 1400mA. (5, 30 and 100%) BTW, it is the 1400mA driver board from Illumination Supply.




6) Mac's Custom EDC SST-50 Warm White
This arrived this week and I am reluctant to offer it up for trade. If anyone has had any dealings with Mac you will know that his lights are outstanding, but communication and wait times have much room for improvement. Also, I had to consider that this emitter is not a current offering.

This is a beautiful, bare aluminum light sporting a 2.8 amp light engine with three modes (low, medium, high) and mode memory. Unlike the newer EDC and Tri-EDC lights, this one will only fit a 16340. IMR is required to safely run this light on high as the current pull on a regular RCR or Primary CR123 would be too much. There are a couple of light handling marks but they are hard to photograph. This has not been carried and is not tapped for a pocket clip. Includes an AW 16340 IMR cell. Photos show low and max output.






7) TorchLab Pocket Stubby XP-G2 Triple
A wall of light in your hand! This runs off of a IMR 18350 but has the ability to be lego'd and run off of 2xIMR 18350, 1/2xIMR 18500, 1/2x18650 batteries. Do not run a primary CR123, RCR123, or IMR 16340 on this!

Compact light (no spring at tail) that uses twisty action. Pure white tint and it always starts on max output (high, medium, low). Head has low voltage protection (run light until it starts to flash, then recharge battery immediately to avoid damage). Photos show low and max output.




8) TnC Titanium Micro-Lux Collector #5 of only 5 made
Mint condition - lightly handled and never carried. Threads are lubed with fyrstormer's (CandlePowerForums) TiTi Twister. UI is twist on twist off, with a quick on and off twist to advance the mode (2 modes). More than a second or two on the current mode and it becomes memorized. Has low voltage protection - light will ramp from high to low and from low to off. Can house 8 trits.

What's included:
  • #5/5 Ti Micro Lux
  • Ti AA/10440 extender
  • 1x10280 battery
  • 2x10440 AW batteries
  • 4xO-rings (2 black, 2 orange)
  • Split ring (uninstalled)
  • N-Cell to AA adapter
Complete Specs:
  • Made from Domestic Ti 6-4
  • AR Coated Glass Lens
  • 2-mode Driver (Hi (550mA) / Low (50mA)
  • Automatically drops from Hi mode to Low Mode when battery gets low (lets you know you should charge the battery)
  • Over discharge protection built in (Light will shut off when battery needs charging)
  • Twist Operation for on/off and mode change
  • When turned on it will blink after 2 seconds letting you know that mode is locked in.
  • Twist on/off/on to change modes
  • Mode Memory
  • Intricate milling pattern on light
  • 6 Trit slots on side of Battery tube (1.55 x 5mm)
  • Two Trit slots on bottom of battery tube (1.55 x 5mm)
  • Key-ring attachment
  • Micro-Lux and a Serial Number will be engraved into the Head
  • Uses the newest Rebel ES LED that produces 160 Lumens / Watt (Tint - W0)
  • Uses 10280 Li-ion Battery (N-cell size) Will be Included
  • N to AA Charging Adapter Will be Included
  • ​Complete Light and Electronics made in USA
  • Only 5 will be produced (Serialized 1/5 - 5/5)



 
Last edited:
Status
Not open for further replies.
Back
Top