WTT: My handmade US silver coin rings for knives

Status
Not open for further replies.
Feedback: +28 / =0 / -0
Joined
Jul 15, 1999
Messages
541
Each of these was made (by me) from an old United States silver dollar. Each is .90 silver.

I can quickly and easily make any of these rings larger by as much as 2 sizes, or smaller by about 1/2 - 1 size (I cannot, however, get dollar sized coins any smaller than about a 10-10.5).

1921 Morgan, Size 12 Sold
20160421_145406_zpsj5kjqqoj.jpg


These 2 rings were made from Morgan silver dollars that had more "wear" on the coin, so I polished out the outer faces and left the inside alone so you could tell that it was made from a coin. Like the others I can adjust the size, but I can also change the finish (brushed or polished) based on your preference.

SPF 1880 (brushed finish) (if you'd prefer, I can quickly polish the brushed finish so it matches the other ring in the pic--just let me know. )
20160122_120141_zpsvnlkwv1l.jpg


This 1921 Morgan has just a little bit of heat damage (you can see it just below the "In God We Trust"). Size 11 1/4,
20160421_145303_zpsqhz1quub.jpg


I also make rings from half dollars (I just don't have any made right now.) Let me know if you have any questions, or if you'd like something made that you don't see here.

Here's what I'm looking for in trade:

Strider SLCC (I can add cash)
Boker Mini Kraiken, G10 scales (already found ti model)
Buck Strider 881 (Looking for the smaller sized clip point version with a plain edge. Would also consider the smaller sized, plain edge tanto version. )
DPX Heat (plain edge--not sure if it even comes serrated)
 
Last edited:
Hi I'm interested in a Morgan dollar ring in size 12. I would like the brushed outside and I think it's the reverse side for the interior. I would like it to say E pluribus unum on the inside so whatever side that is id like on the inside of the ring. You can email me at jjdamatador@gmail.com to discuss payment or trade.
 
Hi I'm interested in a Morgan dollar ring in size 12. I would like the brushed outside and I think it's the reverse side for the interior. I would like it to say E pluribus unum on the inside so whatever side that is id like on the inside of the ring. You can email me at jjdamatador@gmail.com to discuss payment or trade.

Sent you an email (but I clicked on the "Email User" under your username--let me know if you don't get it.)
 
Status
Not open for further replies.
Back
Top