Yes, another grinder motor question?

[couldbe]

Thanks to those that replied.
I'm fairly new to knife making and I'm wanting to made the right motor choice straight away. I'm not looking for the biggest-baddest machine on the block. Just asking opinions from much more experienced people.I'm sure I will be fine with whatever choice I make.
Once again thanks for the feedback,
Mike

 

[PT Doc]

Somtimes you can actually get a better deal on a larger hp motor. I guess its because demand might not have there for 3hp forward to 2hp. If you are patient you'll find a good deal on a nib 3ph motor.

 

[Brett Mathews]

Couldbe I would check these motors out if you have not got one yet they are the same motors that Wayne Coe that sells to many knife makers but at a better value. I also have been using them as well with no complants. Take a look for your self.

http://www.globalindustrial.com/p/motors/ac-motors-2-phase/3-phase-general-purpose-motors/elektrimax-56c-footed-230-460v-3ph-2hp-1800rpm-motor

 

[couldbe]

Thanks for all the advise on motor selection. I did find this document on motor specs http://www.wermac.com/acm_2.pdf lots of good info.

Mike