Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,193
Hello Folks , recently finished this little sweet EDC , time to put it up for your consideration .
This is Hollow Ground from 5/32" A-2 Tool Steel bar stock , it has been heat treated to a hardness of 61-62 as I do all my A-2 steels , it also enjoyed an overnight soak in the minus 110 degree dry Ice bath ( aka sub-zero quench ) .
It is 7-1/2" overall in length with a 3-1/8" blade at 1" wide . Has a fine scotch-bright belt finish on the hollow grind and a 120 grit scratch finish on the flats .
Handled in some stabilized Black Ash Burl with green liners and copper Corby bolts .
Sheath is 7-8oz with a saddle tan dye .
now sold
$135.00 shipped in the USA , pay-pal ,postal m/o or check ( held to clear ) .
Hope you all like it and thank you for viewing my offerings . Comments always welcome .
This is Hollow Ground from 5/32" A-2 Tool Steel bar stock , it has been heat treated to a hardness of 61-62 as I do all my A-2 steels , it also enjoyed an overnight soak in the minus 110 degree dry Ice bath ( aka sub-zero quench ) .
It is 7-1/2" overall in length with a 3-1/8" blade at 1" wide . Has a fine scotch-bright belt finish on the hollow grind and a 120 grit scratch finish on the flats .
Handled in some stabilized Black Ash Burl with green liners and copper Corby bolts .
Sheath is 7-8oz with a saddle tan dye .
now sold
$135.00 shipped in the USA , pay-pal ,postal m/o or check ( held to clear ) .
Hope you all like it and thank you for viewing my offerings . Comments always welcome .
Last edited:
