Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,176
Hello all , I finally finished up this nice little daily companion EDC knife , hope you all like it .
This is Hollow Ground from 5/32" Nitro V stainless steel , heat treated to an Rc. 61-62 with a fine scotch-brite belt finish .
It measures 7" overall in length with the blade at 3" and is 1" edge to spine.
Handled up in some premium stabilized Desert Ironwood Burl with yellow liners and 2 1/4" S.S. Corby Bolts a center mosaic pin and a S.S. lanyard tube .
A leather sheath to be made upon purchase , right or left hand carry .
$140.00 shipped in the USA , pay-pal or postal m/o , checks held to clear .
My PP is sandlot@charter.net.
Thanks for looking and hope you like it . Comments always welcome .





This is Hollow Ground from 5/32" Nitro V stainless steel , heat treated to an Rc. 61-62 with a fine scotch-brite belt finish .
It measures 7" overall in length with the blade at 3" and is 1" edge to spine.
Handled up in some premium stabilized Desert Ironwood Burl with yellow liners and 2 1/4" S.S. Corby Bolts a center mosaic pin and a S.S. lanyard tube .
A leather sheath to be made upon purchase , right or left hand carry .
$140.00 shipped in the USA , pay-pal or postal m/o , checks held to clear .
My PP is sandlot@charter.net.
Thanks for looking and hope you like it . Comments always welcome .




