Z-Tuff chopper

[ShannonSteelLabs]

 

[ShannonSteelLabs]

 

[ShannonSteelLabs]

Shes all done!
Just needs an etch for my logo and steel type, and shes headed out the door!

 

[ShannonSteelLabs]

 

[rodriguez7]

I just picked up a piece of this steel! I’m gonna give it a shot with a low temper heat treat! Aiming for 58-60 rc. Can anyone recommend an austenize starting point? I only have enough to run 1 coupon.

 

[Willie71]

I just picked up a piece of this steel! I’m gonna give it a shot with a low temper heat treat! Aiming for 58-60 rc. Can anyone recommend an austenize starting point? I only have enough to run 1 coupon.

https://www.zapp.com/fileadmin/down...ol steels/Z-Tuff PM/ZTuff_PM_Datasheet_US.pdf

 

[rodriguez7]

https://www.zapp.com/fileadmin/download/03-orange/02-werkzeugstahl/05-werkzeugstahl-17/05-werkzeugstahl-US/Datenblaetter/tool steels/Z-Tuff PM/ZTuff_PM_Datasheet_US.pdf

I ended up finding this data sheet. Thanks! Im thinking I’ll start around 1925 with a 30 minute soak. See how that goes.