Here's a great user for someone who wants such. I was very excited to get it and mod it, and it's great but reluctantly I must admit the handle is a wee tad too short for my paws.
Got this used with the anodizing (part of the lock bar wasn't quite done right and is shiny), then I waved it and ground in a bit of the blade where the edge meets the flipper to change the profile slightly b/c it bugged me. Also sanded the hardware from black to satin. Finally sharpened it at a more acute angle so it actually slices now. The blade is centered, it flips out with authority, it shaves easily. The wave works very well but it might ibe tough on business slacks if used too often. It's not a professional job but it's not bad at all.
So - if you actually want a user 801 this is your baby. Asking $105 shipped and paypalled.
the mark over the pivot is a photo artifact it's not present on the knife
Got this used with the anodizing (part of the lock bar wasn't quite done right and is shiny), then I waved it and ground in a bit of the blade where the edge meets the flipper to change the profile slightly b/c it bugged me. Also sanded the hardware from black to satin. Finally sharpened it at a more acute angle so it actually slices now. The blade is centered, it flips out with authority, it shaves easily. The wave works very well but it might ibe tough on business slacks if used too often. It's not a professional job but it's not bad at all.
So - if you actually want a user 801 this is your baby. Asking $105 shipped and paypalled.
the mark over the pivot is a photo artifact it's not present on the knife
Attachments
Last edited:
.