2 Emersons and a Backwoods fixed blade up for trade!

[benchwarmer380]

Hello BladeForums!

USA trades only. It is your responsibility to know your own laws.


All offers are welcome, although I don't have any particular interest in balisongs, OTFs, or traditionals. Please send offers through email or PM.
If you would like more pictures or have any questions don't hesitate to ask.

Trade interests in no particular order. Cash can go either way.
Emerson: Hattin, Tiger, HD-7 or the new models. Those are preferred, will consider other Emersons.
Spyderco Schemmp bowie or Lum tanto folder, maybe others.
ZT 450 maybe an 808
Microtech Socom Delta. Satin or stonewashed, plain edge drop point.
CRKs
Fixed blades or folders from our forum makers. Alan Davis, Phil Tham, O'Neill, Hall Handmade, Backwoods... I could fill the page with a list of makers...
Maybe a Kizer Cucchiaria Dorado or Flashbang
Citizen TI eco drives or other watches.
Maxpedition Sitka S type. Other packs considered.



The knives!
Emerson rebladed Commander in M390
Emerson CQC 10
Backwoods fixed blade

Descriptions of the knives are in the second post and pictures in the third.

 

[benchwarmer380]

The knives!

Emerson CQC 10. Used but still in good shape. It has a V edge, done by the previous owner on either a WE or EP. He did a very good job. I dropped it once so there is just a small bit of jacked up edge about a half inch down from the tip. Very minimal though, a few passes on a stone will take it out. Normal wear on the clip. Normal wear on the g10. Solid lock up with no blade play. The blade sits nearly centered just a hair towards the clip side. Comes with a box that has seen better days.

Rebladed Emerson Commander. Used but in solid shape. One of a kind! It has an m390 blade made by Reese Weiland and was later shaped to its current state by Charlie Mike. The blade is thicker than standard Emersons so it does not have room for any washers. Still opens smoothly though. I can easily thumb it via the wave hook. The tip is rolled a little bit but it will sharpen out (I'm not skilled enough to mess with higher end steels). Some marks on the g10, pivot screw and the clip. Locks up solid with no blade play. The lock will stick a little bit when waved. The blade sits a little towards the clip side. No box nor the original blade/washers.

Click HERE to see comparison spine shots and measurements of the Commander. They're in post #7.

Backwoods recurve fixed blade. Lightly used. I believe it is made out of 1095. .15 thick. 8.5in overall with a 4.25in blade. About 4in of cutting edge. Very light patina. Not sure what wood the handle is made from, maple perhaps. Lots of character though. Sits in an attractive, tooled leather sheath.

 

[benchwarmer380]