G L Drew
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 3, 2005
- Messages
- 4,490
When this knife was 95% done I took a little more off the handle to make it fit just right. RATS, I sanded into the epoxy that holds the hidden tang. I just can't bring myself to remove the handle and start over so here is a bargain if someone can live with it.
1095 high carbon steel
Heat treated to Rc 58- 60 using three normalizing and two tempering cycles creating a fine grain structure throughout the blade
Flat to a slight convex grind
Professionally stabilized walnut handle with brass and Micarta spacers
Overall Length: 11 1/2 inches
Blade: 6 1/4 inches
SOLD delivered within the US. My PayPal and email address is gldrewknves@gmail.com
IMG_7021 by Gerald Drew, on FlickrIMG_7023 by Gerald Drew, on FlickrIMG_7024 by Gerald Drew, on Flickr
OopsIMG_7025 by Gerald Drew, on Flickr
1095 high carbon steel
Heat treated to Rc 58- 60 using three normalizing and two tempering cycles creating a fine grain structure throughout the blade
Flat to a slight convex grind
Professionally stabilized walnut handle with brass and Micarta spacers
Overall Length: 11 1/2 inches
Blade: 6 1/4 inches
SOLD delivered within the US. My PayPal and email address is gldrewknves@gmail.com
IMG_7021 by Gerald Drew, on FlickrIMG_7023 by Gerald Drew, on FlickrIMG_7024 by Gerald Drew, on Flickr
OopsIMG_7025 by Gerald Drew, on Flickr
Last edited: