A2 and D2 rounds interest?

[Burton Harruff]

I have a chance to get some A2 rounds and D2 rounds around an 1" thick and maybe 2" thick is this something people would be interested in? I am just checking before I pick it up. Let me know.

 

[Burton Harruff]

I see alot of people are looking at this post but no responses. I don't know if I should buy it up or let it go to scrap? I was just curious as to interest in it before I buy a bunch up.

 

[Phillip Patton]

How much would it cost? I might be interested in the 1" round.

 

[Burton Harruff]

I would have to figure out the cost for sure but it would be a good price. I might go ahead and pick up some of it and post it up. I will let ya know Phillip once it is in.

 

[tsf]

Depending on price, I might be interested.
Terry

 

[Phillip Patton]

I would have to figure out the cost for sure but it would be a good price. I might go ahead and pick up some of it and post it up. I will let ya know Phillip once it is in.

Ok, thanks. I'd especially be interested in the D2.

 

[Burton Harruff]

Went over today and checked it out and it looks like they got rid of most of the D2. They had lots of A2 left in 1" round and 3/4" round. I am not sure if I should get it or not. If I did I would probably sell it at $3.00 a pound. If there is any interest let me know if not it is going to scrap.

 

[Phillip Patton]

I think I'll pass on the A2, but if you can get any D2, even the 2" stuff, I'll take some.

 

[Steve Hayden]

I would hesitate on the D2 rounds, especially 2", but I hand forge. I have been using 3/4" A2 rounds of and on for a couple of years and it makes a fine knife. It is very stiff stuff under the hammer, noticably harder to forge than 52100.