Jerry Busse
Moderator
- Joined
- Aug 20, 1999
- Messages
- 11,991
While cleaning out an old desk, Amy-0 came across a Chef's knife pattern that I made back in the late 80's. . . . (The blade pattern is marked Feb. 19, 1987) I designed it with feedback from a couple of professional chefs.
I designed it to allow for full rocking motion along the cutting edge without banging your knuckles. It was also made wider at the tip for fine chopping. Some of the originals had grooves or fullers just under the spine for gripping along the entire top of the blade. . .
I never made them out of INFI because I didn't have stock that was wide enough. . . .
I promised to make one for Amy-0 because she offered to make me a cheesecake!!!!! . . . It will be made out of ATS-34 since I still don't have the right width stock in INFI.. . . .
Jerry
I designed it to allow for full rocking motion along the cutting edge without banging your knuckles. It was also made wider at the tip for fine chopping. Some of the originals had grooves or fullers just under the spine for gripping along the entire top of the blade. . .
I never made them out of INFI because I didn't have stock that was wide enough. . . .
I promised to make one for Amy-0 because she offered to make me a cheesecake!!!!! . . . It will be made out of ATS-34 since I still don't have the right width stock in INFI.. . . .
Jerry



