Apex Edc

Mark Roe

Mark Roe

Feedback: +0 / =0 / -0
Joined
Oct 24, 2005
Messages
78
I have a dozen of the APEX models ground and am getting ready to finish them up. Scale options are black paper micarta or black/grey G10. Here is a picture of the micarta scaled one:

apexmdl1.jpg


Now the details:

APEX - 1/8" D2 Steel. Heat treated to 60.5RC by Paul Bos of Buck Knives. Flat ground main edge and top clip. Bead basted finish. Choice of black/grey G10 or black paper micarta scales. "Nuke" screws. Comes with fitted multi-carry kydex sheath (left, right, horizontal, or neck carry) from Sharpshooter Sheath Systems. Over length is 6 1/4" with a 3" blade. This is an extremely discreet and comfortable EDC knife. $175.00 (US Shipping included).

Ordering is simple. Just email me at info@r2knives.com or use my online contact form and tell me which scale material you would like, initial sheath setup (R or L), and an address.

PayPal is preferred, but checks are fine as well.

Thank you for looking.

Be well,

Mark Roe
 
That is GORGEOUS!!!!!!!!!!! Unfortunately, I'm reroofing the house right now. Bummer!!
 
Thanks for the kind words.

I neglected to add that the top of the knife has thumb serrations .025" apart. Not too grippy, just enough to hold.

It is a three finger grip. Very comfortable, normal grip, reverse grip, blade in or blade out.

Mark
 
#1 - sold
#2 - sold
#3 - sold
#4 - sold

8 APEX knives available.

Thanks for the interest guys.

Be well,

Mark
 
Nice little EDC/utility.

Now, I don't mean to rain on your party but you need a knifemakers membership [or above] to sell here. Just thought you should be aware before a mod comes along.
 
Deweyknives said:
Nice little EDC/utility.

Now, I don't mean to rain on your party but you need a knifemakers membership [or above] to sell here. Just thought you should be aware before a mod comes along.
Click to expand...

Knifemaker membership was purchased earlier today and allowed me to post here. My "moniker" has not been upgraded. Well aware of the rules and believe in playing by them. Can email you my receipt if you like.

Mark
 
Mark,
Nice looking blade! You probably just need to go to the "User CP" section and look in "Group Memberships". You can select to be identified as a knifemaker there.

-Mark
 
Mark Roe said:
Knifemaker membership was purchased earlier today and allowed me to post here. My "moniker" has not been upgraded. Well aware of the rules and believe in playing by them. Can email you my receipt if you like.

Mark
Click to expand...


Read the sticky about updating your user group.
 
mtredmon said:
Mark,
Nice looking blade! You probably just need to go to the "User CP" section and look in "Group Memberships". You can select to be identified as a knifemaker there.

-Mark
Click to expand...

Perfect. Thanks for pointing me in the right direction. Should be ok now.

Mark
 
Hey Mark, after busting on you about your membership,the least I can do is give ya a bump from page 3. :o

No disrespect intended!!! Good luck w/ sales, looks like a great user!! :thumbup:
 
Randy,

No worries. I re-read my reply and it came out kind of bristly.

Take care and thanks for the bump.

Be well,

Mark
 
You must log in or register to reply here.
Back
Top