Club Platinum.. 2011 FIRST TRIMESTER

Status
Not open for further replies.
Actually with read outs. Its not. But there couldn't be a even number. With such large cuts. The ends would look weird. Mabey with much smaller endmill. It would work
 
Jeremy Horton said:
2011-02-17_16-22-05_683.jpg
Click to expand...

That is TWISTED in the best way possible.
 
Jeremy Horton said:
I can but symmetry is important more important than function. Lol
Click to expand...

Now that is funny:thumbup::thumbup:

While not symmetrical, it would still have 2 sides


...................unlike a chisel




:D


If one were to use it, "offset" teeth would be more efficient rather than 2 parallel points catching whatever material is being sawed.
 
Jeremy Horton said:
Jimmy LILE did it this way
Click to expand...


I wanted one of those First Blood knives when they came out. I read a review where they used the saw back to cut through an aluminum canoe. If I remember correctly they were only around $300. Too bad I was only 12 and my allowance was $2 a week.:D


BTW, Jeremy did you get any of that hollow 1.25" round bar in yet?
 
Thanks everyone, I am doing ok. I get pissed occasionally because I am a very independent person but have to have help to do almost everything, I almost started throwing thing yesterday when I fell and couldn't get up without help.

Apparently I avoid a lot of drama by only coming to the platinum club. There are very few other makers or companies out there that will ever see my money now that I know J. My favorite Horton is my damascus necker because she is the only one.

If I wanted to get a convex edge onto my Emerson Commander (it is half right already being a chisel lol) can I do it myself or would that be a huge pain?
 
11aabn said:
Thanks everyone, I am doing ok. I get pissed occasionally because I am a very independent person but have to have help to do almost everything, I almost started throwing thing yesterday when I fell and couldn't get up without help.

Apparently I avoid a lot of drama by only coming to the platinum club. There are very few other makers or companies out there that will ever see my money now that I know J. My favorite Horton is my damascus necker because she is the only one.

If I wanted to get a convex edge onto my Emerson Commander (it is half right already being a chisel lol) can I do it myself or would that be a huge pain?
Click to expand...

Get better mang. Sandpaper and a mouse pad, it's not too hard.
 
Good morning all. I have been out partying the last few days for my birthweek. Hope all is well with everyone and nobody is sick any more. Lot of that still going on here at home and work.
 
Status
Not open for further replies.
Back
Top