I need to free up some funds, so I'm mainly looking to trade down (Cash coming from you)
Items of interest: Northwoods Hawthorne, Bullet, Burnside, or maybe Fremont. 2 blade GEC TC Barlows in long pull spear or clip. Clip point 2 blade Washington jacks. Long pull clip 2 blade western outlaws. Detecting a pattern? I like long pull clip 2 blade jack knives (same end, not a blade at each end). I'm really open to anything though, multiples are fine, but like I said, I do need to cash out a little. Modern knives considered, but it'll be a long shot. A Mnandi would get my attention. Also might be interested in a pen like a mover or shaker, Maxmadco, TiBolt, etc.
3-7/8ths closed length CPM154 blade/backspring, Carbon Fiber covers with end cap. Mill relieved liners.
Condition: It's been lightly carried, so there may be a small mark or two on the bolsters. There was a scuff on the pile side, but I buffed it out, matching the finish elsewhere on the knife, i.e. you can't tell that I've done anything. The knife didn't come especially sharp, so if you're going to want to use it as a serious cutter, you'll need to sharpen it. Only other thing that's a bit quirky is that the swedge is eversoslightly deeper on the mark side than the pile side. This doesn't bother me, the deeper cut makes for a better profile with the long pull, but DrT did offer to fix it for me if I decided it was a problem. Spring is dead flush in all three positions as well.
Album here: https://photos.google.com/share/AF1...?key=ekdWcXAtVFdDY192WE1EclZfY3NJanJ6S3drMUJR
PM me here or send email through forums.
Items of interest: Northwoods Hawthorne, Bullet, Burnside, or maybe Fremont. 2 blade GEC TC Barlows in long pull spear or clip. Clip point 2 blade Washington jacks. Long pull clip 2 blade western outlaws. Detecting a pattern? I like long pull clip 2 blade jack knives (same end, not a blade at each end). I'm really open to anything though, multiples are fine, but like I said, I do need to cash out a little. Modern knives considered, but it'll be a long shot. A Mnandi would get my attention. Also might be interested in a pen like a mover or shaker, Maxmadco, TiBolt, etc.
3-7/8ths closed length CPM154 blade/backspring, Carbon Fiber covers with end cap. Mill relieved liners.
Condition: It's been lightly carried, so there may be a small mark or two on the bolsters. There was a scuff on the pile side, but I buffed it out, matching the finish elsewhere on the knife, i.e. you can't tell that I've done anything. The knife didn't come especially sharp, so if you're going to want to use it as a serious cutter, you'll need to sharpen it. Only other thing that's a bit quirky is that the swedge is eversoslightly deeper on the mark side than the pile side. This doesn't bother me, the deeper cut makes for a better profile with the long pull, but DrT did offer to fix it for me if I decided it was a problem. Spring is dead flush in all three positions as well.
Album here: https://photos.google.com/share/AF1...?key=ekdWcXAtVFdDY192WE1EclZfY3NJanJ6S3drMUJR
PM me here or send email through forums.
Last edited:
