Edge retention of the One Piece line

<font face="Verdana, Arial" size="2">Originally posted by Chris Reeve Knives:
I guess if we started cutting the thread of every butt cap at a given point, we could get the lanyard hole sit at a specific place on the handle. This would presuppose that the thread on every handle was also begun at a specific point. To interpret the above two sentences, please read - production nightmare! However, I do appreciate your comments and will pass them along!

Anne</font>
Click to expand...


Just wondering outloud if anyone has tried using shims to adjust the final position/orientation of the cap at a particular torque?

The Chris Reeve One Piece Range knives rule; they really perform.

Lanyard hole, schmanyardhole ...; BTW, mine is at 1130/0530 on my P1, just in case anyone cares
smile.gif


[This message has been edited by Nimrod (edited 04-17-2001).]
 
You must log in or register to reply here.
Back
Top