Etched 01 tool steel, Scandi grinds, and Jade G-10

chainring

chainring

Feedback: +69 / =0 / -0
Joined
Jul 20, 2008
Messages
2,297
Here's an extra that could go to a good hand somewhere! This is 1/8 thick 01 Tool Steel, heat treated by Peter's to 56-58, scandi ground at 12.5 degrees, etched and blued, with fat Jade G-10 and black micarta pins/stainless lanyard tubing. The edge was taken to 220 on the KMG, and it's hair-poppin' sharp. Overall length is 7.25, blade is 2.75 from tip to scales, and 1.25 from edge to spine, and handle is 7/8 at it's thickest point. Remember folks, I've only completed 4 knives, so none of my work is flawless. I've got a list of things to improve every time I finish one, and I look forward to any buyer's feedback. I've included a serviceable kydex sheath which is ready for the attachment of your choice. I can include a small tek-lok (will fit up to 1.5 inch belts) for an extra $10, which is what they cost me. Payment by Paypal preferred.

Ships by Priority Mail with Confirmation, and price includes shipping to the CONUS.

This one is SOLD!.SOLD!

Thanks for looking!

DSC09899.jpg


DSC09900.jpg


DSC09901.jpg


DSC09902.jpg


DSC09894.jpg


DSC09895.jpg


DSC09890.jpg
 
Last edited:
Very Nice Chain! I really like the Pin layout. You are pumping them out like hot cakes.
 
I alway felt that there was a need for knves that had clean lines,were functional in design,and had no frills. You have hit a home run with your knives my friend.
 
Seconds please, but I'm sure this one is long gone :)
Email sent, I would love to be in line for the next Jade Scandi just like this.
You're off to an awesome start, well done!
 
I got it today & it's perfect folks.
Thank you Mathew & sorry,I have no negative comments for you.
The fit & finish/attention to detail is outstanding!
 
You must log in or register to reply here.
Back
Top