Hey all!
So after years of searching I finally found one of these and I've decided to let it go. Have this up for sale as well and after countless inquiries nobody could pull the trigger. I figured I'd put it on the trade block to see what's out there. Looking for any combination of custom folders, mid-techs and cash.
The one knife I am particularly looking for is a Diskin Flipper, other than that, let me know what you have.
What we have here is a full custom kwaiken flipper, done up in full ti with some of the best orange peeling I've seen. The texture is a favorite of mine and this execution is flawless. The handle, liners, spacer and even the clip have been orange peeled. The blade is CPM 154 with Lucas' gorgeous and highly sought after hand rubbed satin finish.
Blade is 3.5", Handle is 4.75"
This has been lightly carried but never used, still has the original edge and still slices paper clean. The ti does show some extremely light carry marks in the right lighting but they were very hard to capture.
The liners are lightly anodized bronze and the handle and pivot screws have been lightly bronzed as well. Flips perfectly on IKBS as it should, blade is dead nuts centered and lockup is right at 50%. I can take a lockup pic if any serious inquiries request one, just let me know.
Enough out of me, here are the goods...
So after years of searching I finally found one of these and I've decided to let it go. Have this up for sale as well and after countless inquiries nobody could pull the trigger. I figured I'd put it on the trade block to see what's out there. Looking for any combination of custom folders, mid-techs and cash.
The one knife I am particularly looking for is a Diskin Flipper, other than that, let me know what you have.
What we have here is a full custom kwaiken flipper, done up in full ti with some of the best orange peeling I've seen. The texture is a favorite of mine and this execution is flawless. The handle, liners, spacer and even the clip have been orange peeled. The blade is CPM 154 with Lucas' gorgeous and highly sought after hand rubbed satin finish.
Blade is 3.5", Handle is 4.75"
This has been lightly carried but never used, still has the original edge and still slices paper clean. The ti does show some extremely light carry marks in the right lighting but they were very hard to capture.
The liners are lightly anodized bronze and the handle and pivot screws have been lightly bronzed as well. Flips perfectly on IKBS as it should, blade is dead nuts centered and lockup is right at 50%. I can take a lockup pic if any serious inquiries request one, just let me know.
Enough out of me, here are the goods...
Last edited: