Guess what's in my box

[JTknives]

Ok i thought i would see if you can guess what is in my wooden box and what i'm going to use it for. Its not knife steel just to let you know.

 

[Munky88]

Gun parts?

 

[JTknives]

good guess but no. it is knife related

 

[Phil Dwyer]

The best pieces of Ti you held back from us lesser folk?

 

[JTknives]

The best pieces of Ti you held back from us lesser folk?

no sorry, but i do still have a ton of Ti left if any on wants some. another clue. I cut all thoes pices of metal to a specific size. there just in rough forum now but when i get done with them on the mill thy will all go togather to make somthing

 

[Tinbasher]

can't remember what the call it but it's for cutting steel when it's still hot, with a different blade it can be used to form an integral

Richard

 

[JTknives]

nope,

 

[Keith Willis]

Something for your press?

 

[Stacy E. Apelt - Bladesmith]

press dies for damascus patterns?
Stacy

 

[P.Brewster]

KMG clone?

The little blocks are mystifying me...

 

[indian george]

Parts for a Clone KMG????

 

[techna]

Those long, 2" wide (if I'm not mistaken) pieces look like they could be platen parts. Curved platten parts? I dont know though because they look like they might only be 3/8" thick. Hard to get an idea of the scale of things but am thinking the box is 1/2" plywood, so.....

 

[go mike]

Did you need some paper weights?

 

[JatMat]

OK, here goes Power Hammer.
You have everything else.

 

[gixxer]

Didn't you say you were making anotyher jig for those curved platens?

I will give you my mailing addy so you can send me my prize...

 

[Johnny Warner]

aluminum parts to make a grinder with?

 

[bjalongi]

A mini treadle hammer!

 

[Keith_H]

Parts for a Clone KMG????

That is my guess too. The two bits are the tracking brackets and beside that is the rear support.

 

[R. Mark Lee]

I count ten pieces of metal.

You up for lunch this week?

 

[Guyon]

A letter opener, a bacon press, a kayak anchor, and seven widgits?