Nathan the Machinist
KnifeMaker / Machinist / Evil Genius
Moderator
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 13, 2007
- Messages
- 15,672
*SOLD*
This my skinner pattern again. But I'm offering it here at a discount if you don't want the sheath. Some folks are using these in their kitchen. *shrug*
This has a .015" edge (thin) that I've tapered to .010" (very thin) from the belly to the tip. I did this to give you some meat where you might want to cut a chicken bone, but still have the "cuts like a laser beam" tip. It is relatively fragile, so this is not the knife for everyone.
The wood is Cocobolo.
Blade is 3 5/8" hollow ground, 7 1/4" OAL. $140 with sheath, $120 without sheath. *SOLD*
D2 with cold treatment and tempered to HRC 62. This is a high quality HT that has been proven to perform.
I take checks, cash and money orders. I'm now also taking PayPal.
Thanks for looking,
Nathan
This my skinner pattern again. But I'm offering it here at a discount if you don't want the sheath. Some folks are using these in their kitchen. *shrug*
This has a .015" edge (thin) that I've tapered to .010" (very thin) from the belly to the tip. I did this to give you some meat where you might want to cut a chicken bone, but still have the "cuts like a laser beam" tip. It is relatively fragile, so this is not the knife for everyone.
The wood is Cocobolo.
Blade is 3 5/8" hollow ground, 7 1/4" OAL. $140 with sheath, $120 without sheath. *SOLD*
D2 with cold treatment and tempered to HRC 62. This is a high quality HT that has been proven to perform.
I take checks, cash and money orders. I'm now also taking PayPal.
Thanks for looking,
Nathan
Last edited: