I have a question for you all.

Carl, I have a bunch in my collection Here's a pair of CAMMILLUSes - Cammillusi? The pearl is older. Both are the required 2 7/8" closed. Barry
PNUTS%20FT%202.jpg
&
PNUTS%20BK.jpg
 
I had two of them (peanuts) once...my wife now carries one in her purse, my daughter the other one.

The '18 Case stockman is the smallest I'll carry.
 
I've got a peanut or two.......and a rubber chicken.
Got another one on order. This is one in Case's new line of CV stag knives. Due out next month. Not just peanuts but 4 other models; stockman, jack, 2 sizes of trappers. I like these. No shield, CV blades, and stag.

IMG_0374.jpg

58133.jpg
 
I am seriously embarassed to admit, I have no Peanut.:o
Go ahead, kick me out. I deserve it.:(
 
Sorry JK my mitts are too large. I cant stand how small it is. So count me among the ones who doesn't have a peanut.
 
Had one as a kid, but always used my trapper or stockman instead. I don't even remember who made it :o I should get one for office use, since it is nice and small (seems even my Vic Bantam scares the sheeple).
 
I had one, but it was given away. It wasn't that I didn't like it, I was mainly just thinning out the herd and it was one of the knives I picked to leave. I've been thinking about getting another one, just because those thin blades get blazing sharp with ease.
 
If these are peanuts (and I am not clear on this), then I own exactly two. And I am politely refraining from a number of clever tasteless little jokes. I especially like the old Cutco. For some reason I have not laid in a supply of small knives, but that could change. I usually carry something in the 3.75 to 4.25 inch range with two or three blades, in my pocket.

peanuts001.jpg
[/IMG]
 
No Peanut, looking for one in Amber bone with CV blades. I would settle for a yellow handle in CV but have not found one I like. I have a few USA Schrades that are close, 12OT, 8OT an 18OT.
 
Not one here either - for some reason I tend towards migrate toward single backspring models at purchase time. Nice and thin.
 
I don't have a Peanut. My "little knife" is an Uncle Henry mini-stockman, with genuine staglon scales. It's hard to read the number, it's a Schrade+ 807UH or 607UH, I can't tell which. It's well under 3" long closed.
 
I don't own any peanuts. I have nothing against small blades but I'm not a fan of small handles. I have a congress, 1 trapper, 2 stockmen, a whittler and a Soddie and thats all for the traditional side.
 
No peanut, just a 309 with blades on opposite ends. BUT, I get a pass JK because I just talked about Buck needs to make a peanut in the Buck Forum single blade thread........300 ch
 
I confess: No Peanut for me either. I'll probably get one eventually. They just seem a bit too small for me. But I guess I need to give them a chance and try one out. If it's really too small, I'll probably just give it away.


But my dog is named Peanut, if that counts for anything.
 
You must log in or register to reply here.
Back
Top