- Joined
- Aug 16, 2008
- Messages
- 222
The flange on the bottom of your anvil stand looks like a 900# or 1500# ANSI flange. I can't remember the bolt patterns, so I can't tell for sure.
I like that EDC design. You give it a good bit of point. Very nice.
-
The BladeForums.com 2024 Traditional Knife is available! Price is $250 ea (shipped within CONUS).
Order here: https://www.bladeforums.com/help/2024-traditional/
I took the plunge into Knifemaker
- Thread starter mattwheaton
- Start date
The flange on the bottom of your anvil stand looks like a 900# or 1500# ANSI flange. I can't remember the bolt patterns, so I can't tell for sure.
I like that EDC design. You give it a good bit of point. Very nice.
- Joined
- Jul 9, 2006
- Messages
- 168
I picked it up in a barn here in town. I was afraid it was cast, but it turned out to be steel obviously. I am a bit of a steel scrounger. Alot of my tool are made from other things. Are you a structural engineer?