Stacy E. Apelt - Bladesmith
ilmarinen - MODERATOR
Moderator
Knifemaker / Craftsman / Service Provider
- Joined
- Aug 20, 2004
- Messages
- 37,827
Okay....I had to do the nickel test on my new KMG.
Just got the 220 hooked up to it today.
Set the nickel on it's edge at the end of the tool arm and started at about 10% and slowly took it up to 100% and the nickel didn't move.
Nice and smooth.
I've still got some work left, but it's getting there. It will be nice to get away from the 1x42 Kalamazoo I've used since 2011, even though this is only a hobby for me.
It's good to see all the options out there for people right now.
Stumps,
I see a lot of people placing their new grinder on the table exactly like yours. I did it too with my first grinder.
You want to pull it forward until the main base plate is flush with the table edge. That places the front of the belt out over the open area. This allows grinding in a vertical position without interference of the table. It also sends the sparks and grit down into a catch bucket or dust collector.