G L Drew
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 3, 2005
- Messages
- 4,490
I made this from a billet that I forged with 135 layers of 15N20 and 1084 high carbon steel
Heat treated in my Evenheat furnace to Rc 58-60 using three normalizing and two tempering cycles to produce a fine grain pattern throughout the blade
Flat to slight convex grind
Linen Micarta handle
Overall length: 14 inches
Blade: 9 inches and 1 7/8 inches deep
Blade thickness is approximately 1/8 inch on the spine at the index finger with a diatal taper to the tip and edge
$350 delivered within the US. My PayPal and email address is gldrewknives@gmail.com
IMG_4589 by Gerald Drew, on Flickr
IMG_4590 by Gerald Drew, on Flickr
IMG_4592 by Gerald Drew, on FlickrIMG_4593 by Gerald Drew, on FlickrIMG_4594 by Gerald Drew, on FlickrIMG_4597 by Gerald Drew, on FlickrIMG_4600 by Gerald Drew, on Flickr
Heat treated in my Evenheat furnace to Rc 58-60 using three normalizing and two tempering cycles to produce a fine grain pattern throughout the blade
Flat to slight convex grind
Linen Micarta handle
Overall length: 14 inches
Blade: 9 inches and 1 7/8 inches deep
Blade thickness is approximately 1/8 inch on the spine at the index finger with a diatal taper to the tip and edge
$350 delivered within the US. My PayPal and email address is gldrewknives@gmail.com
IMG_4589 by Gerald Drew, on Flickr
IMG_4590 by Gerald Drew, on Flickr
IMG_4592 by Gerald Drew, on FlickrIMG_4593 by Gerald Drew, on FlickrIMG_4594 by Gerald Drew, on FlickrIMG_4597 by Gerald Drew, on FlickrIMG_4600 by Gerald Drew, on Flickr