Rehash on the MUCK

Status
Not open for further replies.
I'm not sure I'd do 1/4" 3V.....too heavy, even with a full flat grind and drilled out tang. Plus the 3V I get comes "oversize"...and ends up being more like 0.280" thick. The Nessmuks I make with that steel are super beefy and they have a full 2" blade.

I'll think about it....maybe down the road...run an extra beefy version...?!?...I dunno...good suggestion - I won't forget about it. :thumbup:

Dan
 
Daniel Koster said:
The Nessmuks I make with that steel (3V) are super beefy and they have a full 2" blade.

I'll think about it....maybe down the road...run an extra beefy version...?!?...I dunno...good suggestion - I won't forget about it. :thumbup:

Dan
Click to expand...

I'm on your list for the 1/4" 3V nessmuk, but would love to see that knife with the M.U.C.K. handle, for greater control in chopping. You could call it the NessM.U.C.K. What do ya think, Dan?
 
superfluities said:
I also want a SS option.
(Can we see that knife balanced on some hot chicks willowy finger please?-lol)
Click to expand...

black mamba said:
I'm on your list for the 1/4" 3V nessmuk, but would love to see that knife with the M.U.C.K. handle, for greater control in chopping. You could call it the NessM.U.C.K. What do ya think, Dan?
Click to expand...


You guys are killin' me.....:D :eek: :p


Dan
 
I even think this knife in 3V with under a .20 thickness would be great. More of a slicer and less of a chopper. I have just been real impressed with the stain resistance of the 3V you use.
 
3/16ths would be fine by me, if heat treat is done well 3/16ths is plenty thick in my experience. I would like s30v, I have never owned s90v... but I am open to it. If 3/16ths 3V was an option I think that would be IDEAL!!! :D:thumbup::D
Hope this goes well,
Alex
 
Yes - the 3V I get is typically oversized - it is around 0.200-0.210 in thickness. So, it will be a tad thicker...

Dan
 
Ok guys...."I've made up my mind and counted to three"


I'm going to do these in 3V - the steel will be on its way next week.


Sign up on my Mailing List - link below in my sig line - if you want to be notified of the Official List sign-up. :thumbup:

Dan
 
I just signed up for your mailing list. Please add my name to the preorder list, I would like one of these beauties. I really like your 3V steel knives Dan, I just bought a second 3V Bushcrafter on the exchange. I am glad you decided to make more blades in 3V steel!
 
Will the balance point change much with 3V instead of O1? Might be a little more point forward.
 
Slightly over sized 3V sounds great, I think this will look great with my Survivor ;). Look forward to hearing from you Dan.

Alex
 
Status
Not open for further replies.
Back
Top