Show how you used your Spyderco today.

Tg1kRo7.jpg
 
No photos but I was repairing our yard sprinkler. I dug a big hole and replaced a cracked elbow on a 1 1/4" PVC supply line. In the process I nicked a signal wire for one of the valves. I used my Manix2 LW Rex45 to shave off some insulation to find the broken conductor so I could splice it.
 
Impossible to take a picture, but was repairing a fence some illegal aliens had messed up down here near the border, and was cutting tag ends on 1000lbs zip ties with a spyderco stretch
 
I have been doing some electrical work with my second Spyderco (bought like 20 years ago, Endura combo edge). Cutting tape, corrugated conduit (the kind that you install inside the walls), etc. I confess I have pried open a few pre-cut side opening in the boxes you install on walls...

The picture of prying open the lid on the paint ca in the first page of this thread n made me nervous... can't think of an easier way to snap the tip off of a full flat ground blade.

Mikel
 
You must log in or register to reply here.
Back
Top