- Joined
- May 25, 2007
- Messages
- 15,113
o-k guys i need a bit of help. i have 2 questions #1 im new to this site obvisouly so could somebody please tell me how i go about asking a question without posting it at the end of somebody elses. im not real computer literate so could you tell me how please? q#2 my problem is this. when i drill holes for the pins in a tang or handle the pins are tight to the point of sometimes not fitting at all. if i have a 3/32,1/8or1/4 pin what size drill bit do i use? i see in places on this site when someone mentions bit size they refer to them in numbers i.e #24, #25 ect. i live in the eastern us our hardware stores stock them by fractions of an inch. how do those #s relate to fract. or metric? PLEASE HELP!!!!
some Mod please move this...... Thank you