Thinking about a power hammer in my future

[weo]

To be fair, having a hammer and press AND a rolling mill is "better" for damascus.

I've been looking for a rolling mill for a couple of years, where does one go to find one of these???

 

[Kosa_PL]

You can get MacDonald rolling mill plans and get this to someone to make you one

 

[HSC ///]

Contacted Iron kiss through email. And he replied to say he had retired. Had only his personal hammer left and it was massive.

nice to see you finally on BF Jared
it's been a wealth of information for me.

 

[Don Hanson III]

If air hammer is wanted, one of these would be nice in the shop.

 

[12345678910]

http://www.anyangusa.net/

?

 

[jdm61]

Don, can those still be had? Who took distribution of that line over after Mr. Clark passed? I heard rumors for a while, but have seen nothing since.

If air hammer is wanted, one of these would be nice in the shop.

 

[Don Hanson III]

Don, can those still be had? Who took distribution of that line over after Mr. Clark passed? I heard rumors for a while, but have seen nothing since.

Joe, Someone did take over the distribution of these after Tom Passed, but I can't remember his name. Seems he didn't have any internet presence and no advertising? I do remember he was the president of BAM at one time.

 

[jdm61]

I heard about Neale Steel Works in Oregon and one other guy perhaps loser to you, but there hasn't been a peep on the interwebz since like 2012 form what I can tell. Anyang and Sahinler are about the only self contained hammers you see promoted here in the US. The Sahinlers are very similar if not almost identical to the Say_ma form what I can tell, but I don;t think they had the "tuning" that Mr. Clark did with the Say-Maks.

Joe, Someone did take over the distribution of these after Tom Passed, but I can't remember his name. Seems he didn't have any internet presence and no advertising? I do remember he was the president of BAM at one time.