What's your Near Perfect Knife?

[Bill1170]

My near perfect folder is my smurf blue M390 PM2.

 

[sabre cat]

zt 0804cf almost perfect... When closing you have to shove it over the detent but oh well. I just wish I could bring myself to use it....
EDIT: It also doesnt have a proper sharpening notch... Still perfect in almost every other way

Generally, I don't care for ZT knives but, I kinda like this one.

 

[Officer's Match]

It doesn't hurt to try.

My "near perfect" getting a little closer with some mods.

De-flipper? I've often thought that would be awesome, making it the perfect Spyderco. More pic's please...

 

[colubrid]

I liked it so much I got 3 of them. I guess the duracoat makes them tick better than other Emersons. Also all 3 were prefect quality control and detent:

Emerson special edition Freedom Defender CQC-7 Flipper model :

 

[Cow51]

Officer's Match I straightened the spine too. I like it a lot, I also have mine on PB washers instead of bearings.

I would like to remove a little more where it protrudes out under the lettering and I need to hit it with a higher grit sandpaper for a better finish.

 

[Officer's Match]

Officer's Match I straightened the spine too. I like it a lot, I also have mine on PB washers instead of bearings.

I would like to remove a little more where it protrudes out under the lettering and I need to hit it with a higher grit sandpaper for a better finish.

Cool, you and I have the identical take on this model, I just need to get one for myself.

 

[marcus52AR]

Officer's Match I straightened the spine too. I like it a lot, I also have mine on PB washers instead of bearings.

I would like to remove a little more where it protrudes out under the lettering and I need to hit it with a higher grit sandpaper for a better finish.

I'd be interested in more info on the PB washer conversion. Lookin good

 

[Cow51]

I'd be interested in more info on the PB washer conversion. Lookin good

Thanks. I used .02x.5x.189 PB washers and the Teflon washers out of a OKC Rat II. With a Dremel I ground out a notch for the stop pin and they fit right in.

 

[Mr.SATism]

The Stan Wilson Non Flipper Flipper for it’s ingenious working. The only reason it’s near perfect is because it’s not in my hand! (Well I also don’t know what steel he uses, but that would ruin the joke haha)