- Joined
- Mar 10, 2013
- Messages
- 1,074
Hello folks here's a couple of nice Nesmuck blades I made from AEB-L. THEY ARE NOT HEAT TREATED. I finished them up to 150 grit then ran them over Scotch-Brite belt. The pinhole is 1/8"and the lanyard hole is 3/8 of an inch. I have not stamped my name on them. They should make a pretty good knife with minimal work.They are .121" thick and .018" behind the edge. I am asking $75 a piece and I can add jimping to the spine for a little extra charge. My PayPal is rhinobucket163@gmail.com
Thanks for looking!
-Eric-
P.S. I'll be finishing these myself.
Thanks for looking!
-Eric-
P.S. I'll be finishing these myself.
Attachments
Last edited: