WTB idler wheel w/shaft and bearings

[Bruce Bump]

I'm working on a grinder modification that requires a 4, 6 or 8" aluminum ider wheel for a 2" wide belt. Straight or domed is fine, Other sizes will be considered especially bigger the better. email or pm me please

 

[David Sharp]

Not sure if this will work; I converted my KMG to direct drive so I have the whole rear section sitting here. Bearings, shaft, and 4" drive wheel.

 

[Bruce Bump]

Not sure if this will work; I converted my KMG to direct drive so I have the whole rear section sitting here. Bearings, shaft, and 4" drive wheel.

You have a price? I may be able to use it if not maybe somebody else here could. A pic would be cool too.

 

[David Sharp]

This is what I have Bruce. These parts new are $182 from Beaumont not counting the mounting plates for the bearings (included with the KMG). I would like $100 +S&H.

 

[Bruce Bump]

This is what I have Bruce. These parts new are $182 from Beaumont not counting the mounting plates for the bearings (included with the KMG). I would like $100 +S&H.

Looks to be a good deal, however I don't need this set up. Anybody care to spring for it? Thanks for the first diggs David.

 

[Bob Katilus]

David, can you post a picture of how your direct drive is set up? I am considering converting over, but not exactly sure how the set up will work.

 

[Bruce Bump]

David, on second thought, if you would throw in the shipping I'd go for it. Sorry for the ups and downs, I'm like an old woman sometimes.
Bruce

 

[Bruce Bump]

Paypal coming David. It'll be handy someday but I still need an idler if somebody has one?
Thanks David