- Joined
- Jun 13, 2014
- Messages
- 1,651
Hello,
I'm selling my ZT0561. This has been carried and lightly used for a couple days to see if I'd like it or not. Not for me. This is the latest generation with the steel lockbar insert. Factory edge is mostly intact with small section of about 1/3" that could be touched up. I only tried it on some mail and some cardboard. There are a couple scratches on the blade but it could have been that way out of the box, can't remember. The handle probably have a couple light/faint miniscule marks from my key as I had it in the same pocket though I don't see any marks. The detent is strong. You will not be able to wrist flick this knife open. Pushing on the blade stop pin is downright painful to open so this is a pure flipper use knife. I switched out the pocketclip screws for some philips ones. the original Torx pocketclip screws are included along with the box (little crushed) and the owner's manual.
WITHDRAWN. KNIFE HAS BEEN SOLD!
Ray
I'm selling my ZT0561. This has been carried and lightly used for a couple days to see if I'd like it or not. Not for me. This is the latest generation with the steel lockbar insert. Factory edge is mostly intact with small section of about 1/3" that could be touched up. I only tried it on some mail and some cardboard. There are a couple scratches on the blade but it could have been that way out of the box, can't remember. The handle probably have a couple light/faint miniscule marks from my key as I had it in the same pocket though I don't see any marks. The detent is strong. You will not be able to wrist flick this knife open. Pushing on the blade stop pin is downright painful to open so this is a pure flipper use knife. I switched out the pocketclip screws for some philips ones. the original Torx pocketclip screws are included along with the box (little crushed) and the owner's manual.
WITHDRAWN. KNIFE HAS BEEN SOLD!
Ray
Last edited:
