Deep carry / low ride titanium clips for Spyderco knives - Delica, PM2, Manix, etc.

Casey are you doing pocket clips for the Southard? I apologize in advance if it was mentioned earlier in the thread, butIi didn't feel like wading through the whole thread if it was.
 
Hi Casey, I'd like to purchase a clip for my yojimbo 2 however it doesn't seem like my PM's are working properly. Would you mind giving me your email or sending me a PM?
 
Hi Casey,
Tried to send you an email (per link above) but it was not recognized.
First of all, very nice product. I read nothing but praise for your quality product and service.

I'm a few hours northwest from you in Canada. Are you able to send a couple into BC?

I have an old stainless delica and a Domino.

Cheers
Sabertooth Mountain Chicken
 
Hey Mr Chicken ;-)
You bet, I would love to send you up a couple to Canada. I actually ship international frequently. Shipping is $7 for any amount.
If your Delica has the same clip hole pattern as your Domino, they will fit. I would suggest a polished short clip for the stainless Delica, and a long sandwashed for the Domino.
You can paypal me at thelastleaf@fastmail.fm, and in the paypal notes, if you could jot down what you're after ('long sandwashed clip, short polished clip' or whatever you decide), that would be great and help me not to goof your order.
Thanks,
Casey
 
Good evening - I would love a short polished (silvery) clip to fit my Yojimbo2 (same pattern as PM2)

Do you put any engraving or patterns on your clips to go with the round hole?

Non-engraved is fine, as long as it's polished to match the stainless hardware (at least roughly match LOL) of the Yojimbo.

Would it be best to discuss via Private Message?

Thanks.
 
Casey, just sent payment for a short clip for a PARA 2, no anodization. Thank you for making these!
 
Hey Thirsty - I would go with the long clip for the Domino. The short clip will work, but the pinch point hit on the lock bar relief cutout.

Casey
 
Hi Casey,

I have a new g10 Native 5 inbound...I am assuming the shorter clip would be the one i need? Also, do you have pics of the heat/flame "anodizing" youve done to these clips? How much more is it to have you flame anodize a short one?
 
Hey pdx - yessir, I think the short clip would be the way to go for that blade. I'm afraid I gave up on heat anodizing. I couldn't get consistently good results. I finally sent Andrew from the Edge Observer a clip to heat ano (he does beautiful work on his beads), and he had the same issue. He figured the thinness of the material was a hinderance in getting the heat ano to work well.
Casey
 
You must log in or register to reply here.
Back
Top