HTM Gunhammer with Ti Framelock and CF/G-10 -- PICS, INPUT NEEDED

DR,

That M390 RAVE is fantastic. Will it ever be a "sprint" or exclusive run?

-chuck
 
Hi Chuck, This steel is made for DDR by Chad Nichols in very small pieces. The steel is very limited. We will make possibly 5 of the knives and that would be all.
 
We have some HTM HAND GROUND Kirby Lambert HTM SNAP Knives available. There are just a few of each.
Blade Steel is XHP. These are a one time specials for the holiday. Three blade grinds.

attachment.php

attachment.php

attachment.php

attachment.php



Email me if your interested in one. dralph@earthlink.net
 

Attachments

  • open.jpg
    open.jpg
    22.7 KB · Views: 401
  • gray_stand_op.jpg
    gray_stand_op.jpg
    13.3 KB · Views: 401
  • opengs.jpg
    opengs.jpg
    13.7 KB · Views: 396
  • natural_green SP grind_op.jpg
    natural_green SP grind_op.jpg
    19.7 KB · Views: 21
  • rear mod tanto blk.jpg
    rear mod tanto blk.jpg
    19.7 KB · Views: 393
Last edited:
You must log in or register to reply here.
Back
Top