Kosa blades :]

Status
Not open for further replies.
Kosa_PL

Kosa_PL

Joined
Aug 25, 2013
Messages
1,220
Hello,
I'm new on this forum, but I have some knives to show :D

This fulltang knives I make from 2,5mm NCV1 steel 10,5cm blade and 12cm cherry handles :)

h2iy.jpg


And now I finishing this knife:

Kosa HYDRA
Blade: 130mm
Steel: O1 3,6mm about 60HRC.
qzg8.png



t19u.jpg


8vn4.jpg


After HT:

owcg.jpg


svs3.jpg


c559.jpg



And now I need to wait about 24h to epoxy set.

yxcg.jpg


Tomorrow I will finish this knife :)

Ps.: I'm from Poland.

Cheers,
KOSA_PL
 
Last edited:
Hydra is very nice. I guess either you really like I stained cherry or not. I must be in the not group but great grind.
 
Nice stuff Kosa.. You need to pony up for a makers membership and start selling! That Hydra should go quick and your fit/finish looks top notch! GL!
 
I will made maybe new Hydra in 6mm NC6 steel (1.2063) , that hydra on photos was sell sometime ago in PL:)

Ps.: Don't have 60$ on B.Account... for membership...
 
Last edited:
Ahh, well, you need to at least add private message ability to your profile and/or email. When you mouse over a persons name, then single click, you have some options like; view profile, add as contact, view posts.. get your email in there so people can contact you :)
 
E-mail added ;)

And tomorrow I'll HT this new knive :)

And now thinking about what to use for handle...

DIY Lindseed cloth micarta ( dark brown) or 20years old European Ash.
 
P 1000 satin ;)

9iof.jpg


HT will be done propably in monday ( now I goin to 3 day hiking on Barania Góra mountain )

And for this knive , handle will be made from European Ash, seasoned for 20 years.
 
And nice small dagger(?) project ;) ( I will make 5 of those from 3,1mm NCV1 steel about 58-60HRC. )

How its look to others ?

thyx.png
 
Last edited:
Status
Not open for further replies.
Back
Top