New ZT0550!!!

Status
Not open for further replies.
I have been wanting a 0350 for quite some time now, but I'm wondering if I should wait on this one. Count me in when it does come out though!
 
mmcc100 said:
I have been wanting a 0350 for quite some time now, but I'm wondering if I should wait on this one. Count me in when it does come out though!
Click to expand...

End of the month if there are no set backs. :thumbup:
One has my name all over it. :cool: :D
 
Isn't the Hinderer stop-button not needed on a lockbar with the cutout on the inside? I always thought that was the case.
 
Tony8179 said:
You're absolutely right, but it can be overextended either way.
Click to expand...

Thanks for confirming. I've yet to bend the little baby frame on the Leek, so I'm not terribly concerned about being too hard on my knives. I've yet to handle an outside cutout blade. Does anyone know of one offhand without a button?
 
From the large post and viewer count it certainly appears this will be a hit.
Hopefully the huge positive response will encourage ZT to introduce even more items.

There do seem to be a lot of bumps, :thumbup: , and other miscellaneous posts in this thread (this may be one too). Could that be due to folks wanting to increase their odds for the free drawing? ;)
 
Tony8179 said:
Better at what?
Click to expand...
Edge Retention in general. I typically want Rc at least 60 for all my knife blades(Typically I don't run into rolled edges at Rc 60+). Enough toughness so that the edge won't chip from something like whittling wood. Stain resistance seems like a moot point for me since I never let even ZDP-189 build up a patina for my use.

After that, I guess whichever has the most wear resistance wins:thumbup:.
 
Status
Not open for further replies.
Back
Top