Order of KAI Official Hang Out; Good Times & Joyous Knives

Status
Not open for further replies.
The locking side will have a round pivot hole, and the non-locking side will have a D-shaped pivot hole. When you put the components together and the pivot gets pushed out, turn it until it seats in the correct orientation in D-hole of the non-locking scale.
 
Ok guys, sorry for the long wait for a response. I saw what you guys mean't with the flat part of the pivot housing. I saw that part right at the beginning, but what I didn't see was the flat part of the torsion bar plate. It even took me a minute to find that once you guy's pointed it out to me. I was able to get those aligned, and then when I sandwiched everything together, the pivot housing DIDN'T pop out this time. I was able to put everything back together without any further hiccups. Thank-you everyone for your help. I really do appreciate it and I know for a fact that I wouldn't have been able to put it back together if it wasn't for you guys. This was a real learning experience for me, and next time I'll make sure to pay attention. I'm glad that you guys stayed with me, and didn't get impatient or panick....like I did. Thanks again for all of your help :).

There was no super glue in the putting back together of this knife....or any knife!

I'm tired so I'm going to go lay down in my nice, warm, and comfortable bed with my phone and chat with you guys from there.
 
I like how even when someones trying to get help from a group of people, you always get that one or two people that don't care if you're struggling, they just sit there and laugh at you, and I like that. Reminds me of my friends during school. I used to do that all the time, so being on the receiving end of the pointing and laughing is fun. It's a nice change of pace. I'll embrace all of the laughing and pointing, and won't freak out and cry like some other people would.
 
Knotty, remember not to panic. If nothing is lost there is no reason it won't go back together eventually. Just relax and study the components, try different configurations and you will figure it out.
 
Status
Not open for further replies.
Back
Top